Medium size Fonts
Blank Base
No Slots on rear of base


Long Arm - Contact between the switch and motor
Contacts glued, not riveted to the chassis

Tooling Revision E
Number of Tools was increased to as many as 24?

Right Side

Left Side

Pin for aligning Contacts is eliminated with this Revision

Slot for the Switch is changed to mounted 180 deg the other way.

All new tooling was done with a flat edge (others are recessed) on this flair for the front wheels.
The original molds 1-4 where left unchanged.

 
All new tooling was done with Smaller fonts and a smaller TM.
The original molds 1-4 where left unchanged.